localsim
0My eSIMs

Guide

How to install eSIM on iPhone and Android

Step-by-step instructions for installing a LocalSIM eSIM on iPhone and Android: scanning the QR code, selecting the data line, and checking connectivity after activation.

Before you start

  • Check that your phone supports eSIM and is not carrier locked.
  • Connect to stable Wi-Fi before installing the profile.
  • Open your LocalSIM QR code email on another device or prepare the manual activation code.
  • Do not delete the eSIM after installation unless you are sure the profile can be reissued.

Installing eSIM on iPhone

  1. Open Settings on your iPhone and go to Cellular or Mobile Data.
  2. Tap Add eSIM or Add Cellular Plan.
  3. Choose Use QR Code and scan the QR code from your LocalSIM email.
  4. Confirm adding the eSIM and wait until the profile activation finishes.
  5. Name the new line LocalSIM, keep your primary SIM for calls, and select the eSIM for mobile data.
  6. Enable Data Roaming for the LocalSIM line if you are using the plan abroad.

Installing eSIM on Android

  1. Open Settings and go to Network & Internet or Connections.
  2. Choose SIMs, SIM Manager, or Mobile Network, then tap Add eSIM.
  3. Choose setup by QR code and scan the QR code from your LocalSIM email.
  4. Confirm adding the eSIM and wait until the profile finishes downloading.
  5. Name the line LocalSIM, keep your primary SIM for calls, and select the eSIM for mobile data.

After installation

  • Turn on the new eSIM only at your destination if the plan is intended for travel.
  • Open cellular settings and make sure mobile data is assigned to the installed eSIM.
  • If data does not start immediately, toggle airplane mode, then confirm data roaming is enabled for the eSIM.